See the difference for yourself!

The Limitations of Conventional Loudspeakers

A. Different impedance curve than woofer
B. Different SPL rating than woofer
C. Different power handling rating than woofer
D. Wide dispersion increases room interaction and diffuses imaging
E. Tweeter signal arrives at ear before woofer signal (in non-time coherent designs)
F. Blown tweeter replacement can cause audible imbalance of sound quality

Tweeter Limitations

A. Circuitry in path of high current (amp) impedes flow
B. Introduction of phase shift into signal (wave cancellation)
C. Inaccurate crossover point alters tonality or can "fry" tweeter
D. Circuitry must negotiate high current and voltage (loads)
E. Crossover replacement can cause audible imbalance of sound quality

Crossover Limitations

Woofer Limitations

A. Different impedance curve than tweeter
B. Different SPL rating than tweeter
C. Different power handling rating than tweeter
D. Low frequency extension commensurate with driver size (bulkier speakers)
E. Woofer signal arrives at ear after tweeter signal (in non-time coherent design)
F. Blown woofer replacement can cause audible imbalance of sound quality

The Cube Answers!

What Does All This Mean?

The time-coherent, low distortion "Cubes" will give you that quick transient response and dynamic range that will make you realize, what you didn’t know was missing has just shown up. The on axis tight dispersion with its pinpoint imaging will have you believing the performance is unfolding right before your very eyes. And the low end response will let you know immediately "somebody’s home downstairs." So if you still don't get it, then get some of our Cubes and find out how we're...defining the art of sound!

Cube Advantages:
A. No woofers, no tweeters and no crossovers
B. Time coherent signal (arrival time of frequencies)
C. Tight dispersion (less effect of room reflections)
D. No circuitry between amp and "Cube" (unimpeded current flow)
E. No crossover phase distortion or driver polarity reversals
F. Matching drivers (no audible imbalances in sound quality if replaced)
G. Amplifier current split evenly between matched drivers
H. No need to bi-wire or bi-amp (mono-blocks work great)
I. Smooth integration of frequencies (no crossover point)
J. Impedance matched 8 ohm drivers (amplifier friendly)
K. Timeless design, quality and exotic finishes
L. Extended bass in a small enclosure

EQC-1 Advantages:
A. Premium parts (clean sound, long life and performance consistency)
B. Wired in before power amp (low current and voltage, less distortion and phase)
C. Small double-sided circuit board (short signal path)
D. Hand soldered, not wave soldered (attention to detail)